라이브러리로시작 
끝 
YouTube에서 보기
운동 라이브러리
Hyperextension (On Bench)
A flat-bench back extension that trains the spinal erectors, glutes, and hamstrings when no dedicated hyperextension station is available.
등맨몸Hip hinge


주동근
척추기립근
협응근
둔근햄스트링코어
장비
맨몸
패턴
Hip hinge
준비 자세
- 01Lie face down on a flat bench with hips at the end and torso hanging off.
- 02Hook the ankles under the bench frame or have a partner hold the legs.
- 03Place hands lightly behind the head or crossed over the chest.
- 04Start with the torso lowered toward the floor and the spine relaxed.
수행
- 01Brace the trunk and squeeze the glutes before initiating the raise.
- 02Extend the hips and back to lift the torso until it is level with the bench.
- 03Pause briefly at the top without cranking into overextension.
- 04Lower the torso back down under control to the start position.
체크포인트
- -Hip crease sits right at the edge of the bench.
- -Torso stops in line with the legs, not hyperarched past them.
- -Movement is smooth, not a swing off momentum.
- -Neck stays neutral rather than craned upward.
흔한 실수
- -Overextending the lumbar spine at the top of each rep.
- -Bouncing out of the bottom instead of controlling the descent.
- -Anchoring the hips too far back on the bench and losing range.
- -Pulling on the head with the hands.
프로그래밍 노트
- -Use 2 to 4 sets of 10 to 15 controlled reps as posterior chain accessory work.
- -Hold a small plate to the chest once bodyweight sets exceed 15 clean reps.
- -Pairs well after squats or deadlifts as low-load spinal erector volume.